[Flexradio] CW Skimmer and PowerSDR

[Tim Ellison]

What is the Stream Format in the VAC channel setup (Control Panel)?  If it is Cable Format change both cables to Cable Range. 



-Tim

-----Original Message-----
From: Phil Theis [mailto:phil at k3tuf.com] 
Sent: Sunday, September 06, 2009 8:38 PM
To: Tim Ellison; flexradio at flex-radio.biz
Subject: CW Skimmer and PowerSDR

Yes, and I tried an earlier version; trunk.
Same results.  PowerSDR only on.  VAC is set up with two cables and Configuration is as in the KB article.
The error is PortAudio Error; Invalid Device.
any more thoughts appreciated.
Phil K3TUF


Did you start PowerSDR and enable VAC before staring CWskimmer? 



-Tim





Using the KB article to set up CW Skimmer Configuration using VAC Direct I/Q I get  the error "invalid device"
Using 5000 and 1.19 of PowerSDR
Any thoughts?
thanks,
Phil K3TUF